memory thrm related warnings/errors on vmware.
Добрый день ! У меня подобная проблема которая тут обсуждалась. Ответа на вопрос я не нашёл и поэтому повторяю : Remote Management Module key : InstalledDevice (BMC) Available : YesBMC FW Build...
View Articles2600cp power fault beep code
Hi, im using an intel s2600cp, with two xeon e5 2620 v1 processors. they are tested working in another system. when i try to power up the system, i get the following error:1-5-4-2Power faultDC power...
View ArticleHNS7200AP Stuck at post code 0x19: SB PEIM
Hi, I've been trying to get a KNL on the HNS7200AP compute module to post, but it seems to be stuck at post code 0x19: SB PEIM, and occasionally resets itself and ges stuck again. Are there any...
View ArticleClik here to view.
Debian Stretch could not find RS2WC040 virtual disk
I'm running Proxmox VE 3.4 (based on Debian Wheezy) on a server with RS2WC040 RAID controller. Trying to install Proxmox VE 5.2 (based on Debian Stretch), installation process shows "The installer...
View ArticleClik here to view.
RS3DC040 RAID controller started to beep with battery module
Dear support, We have one server S2600WT and this RS3DC040 RAID controller with battery.All worked fine over a year, but at some day it started to give an overheating error.But temperatures are Ok and...
View ArticleClik here to view.
Thunderbolt adapter on LGA3647 motherboard
Due to the need of thunderbolt to plug in some professional audio devices, we need to find an add on card for our LGA3647 platforms to provide those thunderbolt ports. The problem is, those adapter...
View ArticleClik here to view.
DBS1200SPSR 3 beeps, High fan speed.
New build with E1230 v5 CPU, 2 x DDR4-233 ECC UDIMM, when powered up the led on the front and on the system board is green, I get 3 beeps and the fans start speeding up to a very high speed but no...
View ArticleR2208WFTZS loud after upgrade to BIOS: 00.01.0014
Hello!On new R2208WFTZS server upgraded firmware package from stock 00.01.0009 to 00.01.0014 and now fans are on 7000RPM all the time.All fan are working and I do not see any errors. See attached...
View ArticleClik here to view.
Intel Server board S2600CW2SR
I have made a server setup with 2 xeon e5 2620-v4 processor.my pc starts but stuck at boot. USB ports are not working as keyboard and mouse are not working. screen stuck at "Warning: This server is...
View ArticleClik here to view.
Poor performance on X722 10 Gb interface
Hi. I have a Lenovo SR650, with Intel X722 10 Gb interfaces. Used as backup server.I have configured teamin using the windows feature in 2012 R2 version. I have also configured teaming interfaces (with...
View ArticleHNS7200AP Stuck at post code 0x19: SB PEIM
Hi, I've been trying to get a KNL on the HNS7200AP compute module to post, but it seems to be stuck at post code 0x19: SB PEIM, and occasionally resets itself and ges stuck again. Are there any...
View ArticleClik here to view.
BB +1.35 P1LV AB
building an intel s2600gz serveros：esxi6.5cpu：2680v2*2memory：Samsung 12800 8g*2BMC Rev：1.28.11044ME Rev：02.01.07.328installed Bios：SE5C600.86B.02.06.E006fouding wrong sensor reading in bmcWhat is the...
View ArticleClik here to view.
R1208WFTYS / S2600WFT
After a firmware update to 1.60.56383bef the server fans are constantly running high and DIMM Thrm Mrgn 1 plus some other sensors show -39 degree or other minus degrees.CMOS reset has been done.Server...
View ArticleClik here to view.
R2208WFTZS POST failure not documented in TPS?
The TPS for the S2600WF server board and the R2000WF series servers offer, in Appendix B (pages 120 and 125, respectively), a diagnostic LED decoder., as shown below.I have a customer who reports POST...
View ArticleServer 2016 Won't boot from RAID Volume After Motherboard replaced
I have a new server with the Intel S1200SPS server mainboard. I installed Server 2016 on a RAID 1 virtual disk, which was setup in the RAID BIOS (ESRT II) with dual Samsung EVO 250GB SSD's. The RAID...
View ArticleClik here to view.
Thunderbolt adapter on LGA3647 motherboard
Due to the need of thunderbolt to plug in some professional audio devices, we need to find an add on card for our LGA3647 platforms to provide those thunderbolt ports. The problem is, those adapter...
View ArticleIntel Server board S2600CW2SR
I have made a server setup with 2 xeon e5 2620-v4 processor.my pc starts but stuck at boot. USB ports are not working as keyboard and mouse are not working. screen stuck at "Warning: This server is...
View ArticleClik here to view.
Unite configuration problem
The server cannot push the pin code, and the debug test indicates the error message.“No servers listed. Trying DNS service record:_uniteservice._tcp”
View ArticleS2600CP invalid dimm configuration
hi there i hope someone knows whats going on herei have the S2600CP motherboard where it works perfectly fine with 2x 2609 cpu´s but will not work with 2x 2660v2 cpu´si have updated the motherboard...
View ArticleClik here to view.
HNS7200AP Stuck at post code 0x19: SB PEIM
Hi, I've been trying to get a KNL on the HNS7200AP compute module to post, but it seems to be stuck at post code 0x19: SB PEIM, and occasionally resets itself and ges stuck again. Are there any...
View Article