Hi,
I come on this board to ask for some help about a motherboard s1200v3rpm that I bought it to build a SOHO server.
The most immediate problem is that there isn't any VGA output signal from the motherboard, so I am quite unable to figure out the situation precisely.
Here is my configuration:
- MB s1200v3rpm, S/N are: pba g62254-405 / bqrp-34600095
- CPU core i3 4350
- 4GB memory DDR3L Crucial (CT51272BD160BJ - officially supported by the motherboard as mentionned on the Crucial site), in A1 slot
- PSU Be Quiet Straight Power 10 (compatible with c6/c7 states)
- nothing else attached (I also tested with a sata 1TB WD Blue 2.5" drive, but it had no impact).
The boot sequence shows the following flashes from status / ID leds (POST code leds stay dark):
- (for 1s) ID: blue blinking 5hz, Status: amber light solid
- (for 7s) ID blue blinking 3hz, Status green blinking 1Hz
- (for 1s) all off
- (for 14s) ID: blue solid, Status: green 1hz
- (for 1 s) all off
- (forever) ID: off, Status: green 1hz
As I understand from the manual, various causes are possible, and BMC is likely not operational.
The problem is, there is no VGA output whatsoever from the MB (I verified cable and monitor with another computer and they are OK), at any moment during the boot or afterwards (so impossible to go to BIOS, etc.).
Also there are no beeps, plugging an usb keyboard before, during or after boot does not produce anything (keyboard seems unactive, as there is no light on caps lock and num lock toggle).
I did the bios reset to default sequence (using the jumper) as instructed in the manual, but nothing changes.
I am quite stuck at this level, if anybody has an idea and/or experienced the same problems, I would be gratefuls of a few hints.
Thanks,
David